Beiträge von shouk_1987

Zitat von Cheesy

Hello,

ok, I think maybe this option is not available and cannot be activated in your "PH2" Kadjar... sorry, but I have no other ideas, too... perhaps additional you can try to ask in the facebook group for "ddt4all"...

so you have done this and then soft-reset...

Der Inhalt kann nicht angezeigt werden, da Sie keine Berechtigung haben, diesen Inhalt zu sehen.

then activated "EG" in cluster and did reset...

Der Inhalt kann nicht angezeigt werden, da Sie keine Berechtigung haben, diesen Inhalt zu sehen.

and last you activated the feature in RLink and did "Hard-Reset"...

Der Inhalt kann nicht angezeigt werden, da Sie keine Berechtigung haben, diesen Inhalt zu sehen.

and after all this, it will not take affect by activating on RLink screen...

I think this will not be possible... at least I don't know any option to change the screen in "reverse-gear-mode"...

Alles anzeigen

The problem is in the first step in activating the EG in ABS ECU , it just doesn't take effect

Someone expert told me that the ExtendedGrip circular switch must be present in the center console so the ABS ECU can accept the command

it is located beside the handbrake button ( I just have a coin pocket instead of the switch )

other parameters are configurable with no problem ( the Custer type 2 and the EG present in Rlink ,

I have already showed it in Rlink but when i press Expert it reverts to auto in 5 seconds )

I was also able to remove the sensors completely from Rlink ( but cannot be disabled in Reverse only )

It is under Audio>HMI>VisualParkAssist >> set to Absent ( kindly add it to the 1st page if you want )

Zitat von Cheesy

I think for this feature does exist an option in ddt4all...

Der Inhalt kann nicht angezeigt werden, da Sie keine Berechtigung haben, diesen Inhalt zu sehen.

but I don't know if it will really work...

Will try and provide my feedback

There is also the Anti Hijack feature in Doorlock in BCM but it would need an easy access to Rlink for turning it ON and OFF when needed

Edit : My trial is in the below post , also Hijack did not work at all ( all doors are unlocked like normal when the car is locked and I unlock it from remote or door button )

I have seen somehwere in a tweaking group on facebook that there is a tweak to enable only driver's door on 1st unlock from inside handle from inside button

Meaning that when the driver open his door then his door only will unlock and not all 4 doors

A far as I know there is no setting for it in Rlink in user settings so it maybe sits somewhere

I have tried to search in Doolock under BCM ECU but could not find it

Also i have set parking sensors in front cluster

Now i really want to remove sensors from rlink so the camera can take the full screen as the screen is not that big

Anyone know how to set both these mods ?

Zitat von Cheesy

no problem, and even more beautiful when it works...

You're welcome and have a nice evening,

Greetings from Carinthia

I have the same problem of not being able to activate ExtendedGrip

I have tried all ABS ECUs and all of them make ABS icon flashes in the cluster but it cannot save Extended Grip feature

I have same errors as well

Edit : note that my car does not have the Extended Grip switch in front of cup holders ( All trims in my country did not have this switch except one year in the last trim if i am correct )

Zitat von Cheesy

Thank you, this is of course also an important note at this point that this probably only works on the PH1 with these window regulator switches..

Der Inhalt kann nicht angezeigt werden, da Sie keine Berechtigung haben, diesen Inhalt zu sehen.

I am attaching panel shape of ph2 with all buttons auto

I have also contacted ali express seller that i already know and dealt with his store earlier for the Qashqai and he confirmed it will not work with all windows auto as stock

Zitat von Cheesy

Yes, that's right, with the "retrofit modules" for the window regulators, of course, that's also possible...

WINSGO Remote Control Auto Car Power Window Closer Close & Open For Renault Kadjar/ Koleos 2017 + Left Hand Stick + Free shipping|window closer|power window closerpower window - AliExpress

I didn't think of that at the moment...

Take care because these retrofit modules are designed for non power windows meaning that your car dorsnot support one touch up or down windows ( i have power windows as stock in Kadjar ph2 )

I have tried many of them in Nissan Qashqai before the Kadjar and I am aware about most of them

I am just wondering why did not Renault implement this as stock while we already have power windows and can roll the windows up from the remote

A thought that it would be a very easy task from ddt4all

Zitat von ewoksman

Moin Cheesy,

It's only possible with the help of the Ali module...

However, the doors are then also open - if you want the doors to remain closed, you can only lower the windows a little (I think about 2 cm).

How os this possible in either too solutions please ?

If i want to have fully opened windows with doors opened ?

And if i want 2 cm of windows opened while doors are closed

I also have a phase2 kadjar model 2020 and only left mirror glass also vibrate or shake above 100 Km/h and want to know the final solution

Hello All,

Is there any possibility to add a funtion to have windows rolling down ( to be opened ) using the remote key ( like a double press unlock or hold unlock button or lock-unlock ) ?

There is already rolling up windows with double lock button but i also need rolling down windows remotely ( i had this feature in former Nissan Qashqai )

sorry for not writing in German as i only speak english

I am going to enable front and rear sensors on the cluster feature however I want at the same time to deactivate sensors from rlink screen only during reverse ( to have full screen camera usage ) but to keep sensors on rlink when going forward ( i donot want to completely disable sensors from rlink )

Is this possible or anyone did it ?